08h00 - 16h30
08h00 - 16h30
Print Bulletin PDF
The US Consumer Product Safety Commission (CPSC) has issued a rule that amends the substantial product hazard list to include seasonal and decorative lighting products that lack specific designed safety characteristics.
Under this rule, seasonal and holiday decorative lighting products are deemed to constitute a substantial product hazard if they lack minimum wire size, sufficient strain relief, or appropriate overcurrent protection. This ruling would subject non-compliant products to recall, and refusal of entry into the United States.
For several decades the CPSC monitored and categorized hazardous incidents involving seasonal and decorative lighting products. This led to identification of product characteristics that relate to prevention of these hazards.
The following characteristics of concern were identified from UL 588, Standard for Safety, Seasonal and Holiday Decorative Products.
• Minimum Wire Size
• Sufficient Strain Relief for Wiring
• Overcurrent Protection
These characteristics are all considered readily observable, and the vast majority of products on the market are in compliance with UL 588. Hence, the proposed regulations are not expected to have significant impacts on industry.
These requirements will take effect on June 3, 2015, adding non-compliant products of this kind to the Substantial Product Hazard List of the Code of Federal Regulations (16 CFR 1120).
Seasonal and holiday decorative products are defined as portable, plug-connected, temporary use lighting products with a 120 volt input rating.
Under the new regulation, sections 6, 7, 15, 71, 79, and SB16 of UL 588 establish the requirements for the necessary characteristics.
Proper wire sizing helps to ensure that no overheating occurs and minimizes the likelihood of physical damage during intended use. The requirements are found in section 6 of UL 588.
Adequate strain relief diminishes undue strain on wires and insulation at points where they enter plugs or lampholders. This helps to prevent damage to the wiring which could lead to overheating or shock hazards. The requirements are found in sections 15, 71, 79 and SB16 of UL 588.
Overcurrent protection prevents excessive current situations, minimizing heating effects. These requirements are found in section 7 of UL 588.
Bureau Veritas evaluates these characteristics as part of our typical test offerings.
Additional Information: http://www.gpo.gov/fdsys/pkg/FR-2015-05-04/pdf/2015-10342.pdf
Contact Information: If you have any comments and/or questions, please contact your customer service representative or email email@example.com
Consumer Products Services
Send an e-mail